Blade server

From Citizendium
Jump to: navigation, search
This article is a stub and thus not approved.
Main Article
Discussion
Related Articles  [?]
Bibliography  [?]
External Links  [?]
Citable Version  [?]
 
This editable Main Article is under development and subject to a disclaimer.

Blade servers are computer servers arranged for high-density installations, such as data centers. They are one of several form factor alternatives for increasing density over the AT-style PC tower. Blade servers, which themselves have form factor alternatives, put several server processors into a an industry-standard 19" wide rack. The standard rack is 42 Rack Units (RU), each 1.75" high; shorter racks are available.[1]

When more than one server is required at a location, and there are no pressing reasons for individual cases such as separate ownership, the "tower" case for AT-style PC cards is considered a very inefficient use of space. One of the first high-density approaches to server installation was to mount the processor horizontally, into a 1 RU chassis commonly called a "pizza box". Another approach, often desirable when the server needs many internal disks or interface cards, is to put mounting hardware, on a tower case, which can bolt horizontally or vertically into a rack, still getting multiple servers into the floor footprint of a single rack. Several free-standing towers quickly use up the floor space of a nominal 25" wide, 24" deep rack.

Blade server concept

The first blade servers put up to eight processors in a 6 RU high rack-mounted chassis. A blade server chassis has integral network interfaces and management tools, although it tends not to have much local disk capacity, assuming network attached storage or a storage area network. To deal with the concentrated heat load, the chassis is designed for efficient cooling, which can be forced air, or chilled water pumped through pipes.

Also improving the density, the chassis may contain integrated routing and switching not needing that interconnect through the board sockets. It also may be equipped with redundant, fault-tolerant shared power supplies, rather than a power supply per server.

Form factor alternatives

Using the full-sized form factor for blade servers, the break-even point when compared to standalone servers is often considered in the range of 5 to 6 servers per blade chassis. Mini blade server, as with products from MDS Micro, put two or four servers into, respectively, 1 or 2 RU. When compared to a full-size solution, the mini alternative can put 12 servers into the same rack space as with full-sized servers, at a lower initial cost but with more overhead for per-chassis power and management.

The MDS products also can have 40 Gbps Infiniband storage area network connectivity, but, if that is not needed, they have two Gigabit Ethernet interfaces.[2] Other blade servers may use the evolving 40 Gigabit or 100 Gigabit Ethernet interfaces rather than Infiniband or Fibre Channel "fabric" interfaces. They lack the network switching and some management that has been standard on full-sized blade servers, but are intended to connect to networked storage via a device that "mixes and matches" Gigabit Ethernet, 10 Gigabit Ethernet and FibreChannel speeds, such as the Xsigo I/O Director[3] or Cisco FabricPath.[4]

References