Note (music)

From Citizendium
Revision as of 10:10, 26 June 2012 by imported>John R. Brews (Arabic music; source)
Jump to navigation Jump to search
This article is developing and not approved.
Main Article
Discussion
Related Articles  [?]
Bibliography  [?]
External Links  [?]
Citable Version  [?]
 
This editable Main Article is under development and subject to a disclaimer.

In music, a note is an abstract representation of the pitch and duration of a tone. The pitch designated by a note is objective only in the case of a simple tone (also called a pure tone) such as produced by a tuning fork, which consists of only a single frequency of vibration, in which case the pitch is uniquely related to that frequency at a given loudness.[1]

(PD) Image: John R. Brews
Frequencies of various pure tones. The various A-notes are a factor of two apart in frequency, an octave (eight notes).[2] The MIDI pitch numbers are explained later.
(PD) Image: John R. Brews
The amplitude of a musical note varies in time according to its sound envelope.[3]

A musical instrument on the other hand, produces a tone, which is a superposition of various frequencies with various amplitudes and phases peculiar to the instrument, and also affected by the manner of play that determines the sound envelope of the note (referred to by Lamb below as "adventitious circumstances"). A laboratory determination of pitch is made by a subject listening to a tone from a musical instrument and to a simple tone, such as that produced by a tuning fork, and identifying circumstances where the instrument and the simple tone sound alike.[4] As a result, for other than simple tones, pitch is not a purely objective physical property; it is a subjective psychoacoustical attribute of a sound.

To quote Lamb:[5]

One musical note may differ from another in respect of pitch, quality, and loudness. The pitch is usually estimated as that of the first simple-harmonic vibration in the series, viz. that of lowest frequency, but if the amplitude of this first component be relatively small, and especially if it fall near the lower limit of the audible scale, the estimated pitch may be that of the second component. By "quality" is meant that unmistakable character which distinguishes a note on one instrument from the note of same pitch as given by another...difference of quality, so far as it is not due to adventitious circumstances, can only be ascribed to differences of vibration-form, and so to differences in the relative amplitude and phases of the simple-harmonic constituents.

Such as the manner in which the sound sets in and ceases; this is different for instance in the violin and the piano.

What Lamb refers to as "quality" of a note also is referred to as the timbre of a tone, that is, the subjective perceived quality of a tone. The tone itself is objectively described by the measured frequency and phase of each constituent of its vibrational spectrum.

Notation

For more information, see: Musical notation.
(PD) Image: John R. Brews
Musical clefs and notes of various durations arranged on the grand staff of eleven lines.

Western music is based upon twelve pitches repeated cyclically over octaves.[6] In Western musical notation, the pitch of a sound is indicated by the vertical position of the symbol for the note on a staff or stave, an array of parallel leger lines (from the French leger=light), as shown in the figure. Certain lines on the staff are identified by clefs. The upper clef is called the treble or G-clef, and the lower clef is called the bass or F-clef.[7]

The names of the notes correspond to the first seven letters of the alphabet, applied to both lines and spaces. The labeling associated with the lines on the staff is indicated, and the labels for the spaces follow alphabetically.[8] Men's voices are considered to range from lower G on the bass staff (the bottom five lines), through the next G in the tenor staff, to to the third G in the in the alto staff. Women's and boy's voices range an octave higher, running up to the next G in the treble staff. See Jones,[7] §24, p.9. For voice exercises, the first note C on the so-called natural scale or scale of C is called doh and the notes of the first octave are named by the syllables doh (do), ray (re), me (mi), fah (fa), soh (sol), lah (la), te (ti), doh (do).[9]

The absolute pitch denoted by a position on the staff is set by the key of the musical piece. Pure tones separated by an octave on the staff (that is, a combination of eight lines and spaces on the staff) are a factor of two different in frequency.

On the twelve semitone scale, also called the chromatic scale, and which corresponds with the keys of the grand piano, a pitch between C and D, say, is called C-sharp (denoted C) and is a semitone above C, or labeled D-flat (denoted D), a semitone below D. A complete cycle of notes on this scale is A, (A, B), B, C, (C, D), D, (D, E), F, (F, G), G, (G, A), A, and so on.[10]

The left-to-right position of the notes on the staff indicate the order in which they are played, the later notes further to the right, with notes directly above one another played simultaneously.

Duration of a note is indicated by its symbol. Examples are shown in the figure, with the longest or whole note at the bottom, and the two half notes above it that combine to the same duration. The quarter note, eighth notes and sixteenth notes are successively stacked above.[8]

The relative duration of a whole note is established by dividing the horizontal length of the staff into measures, bounded by vertical bars, and a time signature that determines how many "beats" occur in a measure, and which note corresponds to a beat. For example, a ¾ time signature means three beats to a measure and a quarter note gets one beat, a half-note two beats, a whole note four beats, and so forth.[11] Musical notation does not assign absolute duration to a beat.[12] Tempo indications, like presto and allegro, provide further guidance for pace.[13]

Digital representation of notes

There are a variety of schemes for encoding music in a digital format. An early version, and perhaps most widespread, is the Musical Instrument Digital Interface or MIDI.[14] A later and more complete scheme is Csound.[15] Next, some detail is supplied about MIDI.

A MIDI file is the digital equivalent of sheet music.[16] In this system, each note is assigned a numeric value with A440 (the A above middle C) given the number 69. The general formula for finding the frequency f of the pure tone associated with the pitch corresponding to a MIDI number n (an integer between 1 and 128 = 27) is:[17]

which inverts to provide MIDI pitch number as:[18]

which is meaningful only for frequencies resulting in integer values of n in the range 1 - 128. Here log2 is the logarithm of its argument to the base 2. With these formulas, middle C with MIDI number 60 is assigned the frequency 261.6256... Hz.

There are 128 = 27 numbers available for digital assignment, many more than the 88 keys of a piano, so many more pitches are possible.[19] The grand piano keyboard (including sharps and flats) corresponds to MIDI numbers 21 - 108 or 27.5 Hz - 4,186 Hz, and the MIDI pitch numbers are shown for the A’s of the grand-piano keyboard in the figure in the Introduction.

The MIDI protocol sends messages that include aspects of pitch, timbre, and timing that allow a music synthesizer to imitate a piece of music played upon one instrument, or even several different instruments, in a predictable fashion.[14] Instructions designated Note-On and Note-Off specify the duration, loudness and pitch of a note. The timbre of a tone is selected by a MIDI Program Change message, consisting of a status byte and a data byte. The data byte identifies a patch number, with patch 20 a church organ and 106 a banjo on MIDI-compatible synthesizers, for example.[20] Not all synthesizers, however, will associate the same patch number with the same instrument.[21]

References

  1. The pitch of pure tones varies somewhat with sound level, perhaps by as much as 5% and varying with the individual listener. Susan Hallam, Ian Cross, Michael Thaut (2011). The Oxford Handbook of Music Psychology. Oxford University Press, p. 50. ISBN 0199604975. 
  2. Based on data from Leon Gunther (2011). “Figure 11.2: Piano keyboard”, The Physics of Music and Color. Springer, p. 357. ISBN 1461405564. 
  3. Stanley R. Alten (2010). “Sound envelope”, Audio in Media, 12th ed. Cengage Learning, p. 13. ISBN 049557239X. 
  4. Thomas D. Rossing (2007). Springer Handbook of Acoustics. Springer, p. 477. ISBN 0387304460. 
  5. Horace Lamb (2004). The Dynamical Theory Of Sound, Reprint of 1925 Edwin Arnold Ltd. 2nd ed. Courier Dover, p. 4. ISBN 048643916X. 
  6. In Arabic music, twenty-four quarter-tones are used instead of twelve half-tones. See Dorothea E. Hast, James R. Cowdery, Stanley Arnold Scott (1999). “The notes of Arabic music”, Exploring the World of Music: An Introduction to Music from a World Music Perspective. Kendall Hunt, pp. 125 ff. ISBN 0787271543. 
  7. Jump up to: 7.0 7.1 F Leslie Jones (1874). “Chapter II: Musical notation”, A manual of the elements of vocal music. Oxford University Press, pp. 7 ff. 
  8. Jump up to: 8.0 8.1 John Taylor (1876). “Appendix B: Notation”, The student's text-book of the science of music. George Philip and Son, pp. 88 ff. 
  9. The assignment of names for notes is more complicated than one might expect, and has an extended history and various schools of practice. See Steven M. Demorest (2003). Building Choral Excellence: Teaching Sight-Singing in the Choral Rehearsal. Oxford University Press, pp. 46 ff. ISBN 0195165500. 
  10. The chromatic scale is only one of many scales. See, for example, (2003) “Scale degrees”, Don Michael Randel, ed: The Harvard Dictionary of Music, 4rth ed. Harvard University Press, p. 758. ISBN 0674011635. 
  11. Michael Pilhofer, Holly Day (2111). “Introducing time signatures”, Music Theory For Dummies, 2nd ed. John Wiley & Sons, pp. 37 ff. ISBN 1118169263. 
  12. Nancy Scoggin (2010). Barron's AP Music Theory. Barron's Educational Series; Pap/Com edition, p. 15. ISBN 0764196316. 
  13. Sandra P. Rosenblum (1991). “Chapter 9: Choice of tempo”, Performance Practices in Classic Piano Music: Their Principles and Applications. Indiana University Press, pp. 305 ff. ISBN 0253206804. 
  14. Jump up to: 14.0 14.1 An accessible overview of the MIDI protocol can be found in Walter B Hewitt, Eleanor Selfridge-Field, et al. (1997). “Chapter 2.1 What is MIDI?”, Eleanor Selfridge-Field, ed: Beyond Midi: The Handbook of Musical Codes. MIT Press, pp. 41 ff. ISBN 0262193949.  The complete MIDI specification can be ordered from MIDI Manufacturers Association.
  15. Richard Boulanger (2000). “Introduction to sound design in Csound”, Richard Boulanger, ed: The Csound Book: Perspectives in Software Synthesis, Sound Design, Signal Processing,and Programming. MIT Press, pp. 5 ff. ISBN 0262522616. 
  16. Robert Bruce Thompson, Barbara Fritchman Thompson (2003). “MIDI Audio”, PC Hardware in a Nutshell, 3rd ed. O'Reilly Media, Inc, p. 577. ISBN 059600513X. 
  17. Eberhard Sengpiel. MIDI notes and their corresponding frequencies. Keyboard and frequencies. Retrieved on 2012-06-23.
  18. Philippe Blanchard, Dimitri Volchenkov (2011). “Equation (8.49) in §8.4.2 Encoding of a discrete model of music (MIDI) into a transition matrix”, Random Walks and Diffusions on Graphs and Databases: An Introduction. Springer, p. 156. ISBN 3642195911. 
  19. Dan Hosken (2010). An Introduction to Music Technology. Taylor & Francis, p. 145. ISBN 0415878276. 
  20. A. E. Cawkell, Tony Cawkell (1996). The Multimedia Handbook. Psychology Press, p. 151. ISBN 0415136660. 
  21. Joseph Rothstein (1994). Midi: A Comprehensive Introduction, 2nd ed. A-R Editions, Inc., p. 184. ISBN 0895793091.